N1GY- The simple Approach to Ham Radio

and My Model Railroad Hobby

​

       This is the second time I have designed and built a dual band portable set-up. The first one used a cheap Chinese dual band transceiver and was permanently mounted on my electric mobility scooter. With only about 20 watts of power and a small 12 volt SLA battery at the rear of the scooter it worked OK but it was not the best. In particular, the audio quality of the little radio was quite poor and I could only use it if I shut the scooter off. Hence operation while on the move was not possible. 

         The new set-up is completely self-contained at the front of the scooter. Hopefully the lack of wires running past the scooter motor will ameliorate the interference from that source. THe new rig has a 30 AH, 12.8VDC LIFePo4 battery mounted inside a plastic ammo can type container. The antenna is of the type that does not require a ground plane and the total run of coax is less than one foot from radio to antenna. I chose the FT-7900R because it has several power settings from 5 watts up to 50 watts and so I can choose whatever is necessary to ensure communications. Although I am retired from ARES due to my age and infirmities, I would still like to participate in race control should the club get asked and do "scooter mobile" should the opportunity arise. Because of my health concerns and mobility issues I have not been as active in my club's activities as I would like. Hopefully this will change with the addition of this portable rig. It is also quite capable of operation without the scooter since it is completely self-contained. I did add an arrangement of aluminum strapping so that I can mount it on my scooter but it does not have to be used only that way. 

    

A NEW PORTABLE DUAL BAND SETUP USING A YAESU FT-7900R.

 This photo shows the FT-7900R in operation. What is not shown here are a couple of last minute additions to the system. One, an external speaker has been added at the opposite side of the lid on the other side of the carrying handle and two, a master switch has been added just behind the control head so that no service time will be lost due to parasitic drain caused by the radio being attached to the battery. This parasitic drain is a common problem with many modern radios. Every radio I own is isolated by a switch so that no drain will occur. BTW I first came across this problem with my Icom IC-706MkiiG which I discovered could drain a car battery is a little over a weekend. The drain was almost 1 amp per hour. Ever since, all my radios are either isolated with an on-off switch or connected to a power supply which itself has an on off switch. I did use a heavy duty toggle switch from Amazon which came with a red hinged cover that automatically shuts the switch off if the cover is lowered onto the switch. 

The photo above shows the aluminum strapping meant to allow the rig to be mounted in place of the usual basket on the scooter. You can also see how the control head is remoted from the main body of the radio which is inside the ammo can with the battery. The silver colored cable has since been replaced with a black one to make it less obvious. and it is also shorter than the one in the photo.

This is a different shot of the lid of the container showing the external speaker and the master switch. The toggle is obscured by the red cover which when pushed will shut off all contact between the LiFePo4 battery and the radio thus preventing any current drain from said battery.

This  is a view of the interior in it's latest iteration. In here are the radio main body, the battery, the charger and instructions on programming the radio should that be required. The black foam in the upper left is there mainly to restrain the main body of the radio. It does not restrict the flow of cooling air through the radio.